Hammer Mill

HM 10


  • Bimetal high chromium beater heads
  • Solutions for extremely demanding feed materials
  • Innovative grinding walls divided in 3 sections
  • Adjustable grinding walls & grate
  • Grinding grate at the bottom (optional)
  • Easy maintenance access


  • Highest lifetime of beater heads/beaters
  • Fully automatic operation
  • Generation of various degrees of product fineness
  • High experience in custom-tailored product particle size
  • Fast and efficient maintenance of crushing tools
  • Fully sensor-controlled to avoid downtimes


  • Hammer mills are used for crushing medium-hard and soft materials (coal, limestone, gypsum, clay, marl, salts, phosphates, etc.).
  • The processing of feed material with increased moisture is also possible in CPC hammer mills.
  • Grinding drying by feeding hot process gas (e.g. flue gas from a combustion) into the hammer mill

Drying and Crushing Application

  • Pressure-resistant housing to comply with ATEX directives
  • Extra tight sealings for working at low O2 conditions
  • Temperature: gases 440° C / for minerals up to 700° C
  • Integrated fire suppression system
  • Throughput: 100 t/h and 2 t/h water evaporative capacity

Mode of operation

  • To break coarse grain, the feed material is caught by the impact hammers and thrown against the upper area of the grinding wall (impact wall).
  • In the middle area of the grinding wall, the material to be ground is ground and shaped
  • In the lower area, the material to be ground can be classified by using a grinding grate (usually bar grate depending on the application, optional)


Sustainable value enhancement of existing equipment with regards to

  • Satisfying continuous operation
  • Whole lifecycle