HYBRID CRUSHER
HC 15
Features
- Solution for hard, medium-hard, and soft materials (ores,
limestone, salt, coal, clay, oil shale etc.) - Weld-on hard-faced crushing teeth with various configurations
for most difficult applications - Integrated flywheel equalizing torque peeks, thus reducing
required motor power - Permanent parallel position of crushing rolls due to hydraulic
“Cross Junction” even in case of partial overload - Efficient crushing of material with less content of fines and low
dust emissions - Monitoring by local operator panel
![](https://cpcgmbh.com/wp-content/uploads/2023/11/CPC-Crusher-02-1-1024x656.jpg)
PRIMARY STAGE
![](https://cpcgmbh.com/wp-content/uploads/2024/02/2_5-300x220.png)
![](https://cpcgmbh.com/wp-content/uploads/2024/02/crushing-segments-quick-change-300x222.jpg)
Crushing segments quick-change
SECONDARY STAGE
![](https://cpcgmbh.com/wp-content/uploads/2024/02/secondary-stage-300x221.jpg)
![](https://cpcgmbh.com/wp-content/uploads/2024/02/secondary-stage-segments-300x222.jpg)
Crushing segments
Advantages
- Highest lifetime of crushing segments
- Fully automatic operation
- Generation of various degrees of product fineness
- High experience in custom-tailored product particle size distribution
- Fast and efficient maintenance of crushing segments
- Fully sensor-controlled to avoid downtimes
Application
- Coarse size reduction of hard, medium-hard and soft material (lime stone, dolomite, magnesia, salt, coal, clay, oil shale etc.)
- Throughput up to5.500 mt/hr, depending on material characteristic and particle size
- Feed material size up to 1,500mm, product particle size down to 300mm possible, 50mm for secondary crushing stage
- Design of crushing teeth according to the material requirements (number, size, position, form, hardness)
![](https://cpcgmbh.com/wp-content/uploads/2024/02/stats-hc.jpg)
![](https://cpcgmbh.com/wp-content/uploads/2024/02/Hybrid-crusher-roll-animation-3D.gif)
Mode of operation
- Combination of the characteristic of the Double Roll Crusher with the performance of the Sizer
- Crushing of feed material by teeth of the two counter-rotating rolls. Successive comminution of larger lumps
- Product particle size regulated by precise setting of the roll gap
- Opening of the gap between the crushing rolls in case of overload (e.g. caused by an unbreakable foreign object) within milliseconds to let that piece pass thus avoiding a shut-down
- Crushing teeth in a spiral on the shaft equalizing torque peeks
- No clogging of the rolls by sticky material due to specifically designed scrapers
- Final product with small portion of fines due to limited speed of the rolls
SOLUTION PROVIDER
Sustainable value enhancement of existing equipment with regards to
- Satisfying continuous operation
- Whole lifecycle
![solution prov hc](https://cpcgmbh.com/wp-content/uploads/elementor/thumbs/solution-prov-hc-1-qmr4bph7v9g8xbaidzu0rqxebikrnvi689aknajd88.jpg)
![Hybrid on site](https://cpcgmbh.com/wp-content/uploads/elementor/thumbs/Hybrid-on-site-1-qmr4brcw8xitkj7s30n9wqgbiabi39pmwiljlugkvs.jpg)